Table of Contents
Advertisement
GA27-4151-02
This edition includes information about two new models of the SureMark printer:
Model TI3 and Model TI4. Because Model TI3 is a new version of Model TI1, and
Model TI4 is a new version of Model TI2, in some cases only the new model
number was added to the existing text.
Information that was added includes:
v "Comparison of the SureMark models" on page 7, which describes the
v "Firmware update" on page 37, which describes the methods that you can use to
v "Enable or disable the feed buttons" on page 143 and "Select maximum print
Information that was changed includes:
v "Software requirements" on page 13, which includes operating system and driver
v "Code page definitions" on page 92. Code page 850, which is resident in Model
v Zero (0) is no longer valid for the EIA-232 command "Microcode tolerance (MCT)
v The Remarks under "Define document wait time" on page 141 have been
Because documentation, drivers, and diskettes are now available on the Web,
"Resources on the Internet" on page 44 was added to describe how to locate the
applicable Web site.
Along with these changes and additions, the manual was also reorganized. The
information that was in Appendixes B and E, along with some additional information,
is now in Chapter 3, "SureMark installation, service, and utility software," on page
33.
xx
SureMark Printers User's Guide
microcode, hardware, and operating system differences.
update the SureMark firmware.
speed" on page 132, which describe new EIA-232 commands.
requirements, and application requirements.
TI1 and TI2, has been replaced in this document by code page 858, which is
resident in Models TI3 and TI4. Code page 858 is the same as code page 850
plus the euro character symbol.
information - request" on page 125.
corrected and expanded.
Updated April 2, 2009
Advertisement
Table of Contents
