Chapter 7. Testing And Problem Analysis (Models Tf6 And Tm6); Testing The Printer - IBM SUREMARK TF6 User Manual

Ibm printer user manual
Hide thumbs Also See for SUREMARK TF6:
Table of Contents

Advertisement

Updated April 2, 2009
Chapter 7. Testing and problem analysis (Models TF6 and
TM6)

Testing the printer . . . . . . . . . . . . . . . . . . . . . . . . 75

Offline test . . . . . . . . . . . . . . . . . . . . . . . . . . 76
EIA-232 hex dump
Resetting the printer - offline . . . . . . . . . . . . . . . . . . . . 78
Problem determination . . . . . . . . . . . . . . . . . . . . . . 78
Note: For translations of these safety notices, see IBM Safety Information—Read
Testing the printer
When you power on the SureMark printer, it runs a power-on self-test (POST). If the
POST finds no errors, the printer is ready for operation. Follow this procedure to
determine if there are errors.
Note: Never connect or disconnect the printer when power is applied (when the
1. If the printer is powered on, power OFF the printer and power it on again.
© Copyright IBM Corp. 1997, 2006
. . . . . . . . . . . . . . . . . . . . . . . 77
DANGER
To avoid a shock hazard, do not connect or disconnect any cables
or perform installation, maintenance, or reconfiguration of this
product during an electrical storm.
DANGER
To avoid shock hazard:
The power cord must be connected to a properly wired and
earthed receptacle.
Any equipment to which this product will be attached must also
be connected to properly wired receptacles.
This First, GA27-4004.
LED is on).
v If the printer is attached to the system with the EIA-232 cable or the standard
USB cable with a power brick, disconnect the power cord, then reconnect the
power cord to a properly wired and grounded power source.
v If the printer is attached to the system with the RS-485 cable, power OFF the
POS system, and then power on the system, which also powers on the
printer.
v If the printer is attached to the system with a powered USB cable, the USB
attached printer can be hot-plugged.
v For single-station printers, use the printer's power ON/OFF switch that is
located under the top cover. Power OFF the printer, then power ON the
printer.
75

Advertisement

Table of Contents
loading

Table of Contents