Table of Contents
Advertisement
Updated April 2, 2009
Commands with limited support in emulation mode
The commands listed in Table 29 are supported in a limited manner in Epson
emulation mode. The table describes the limitation on each command.
Table 29. Commands with limited support in Epson emulation mode
Command
10 04 n
Real-time status
transmission
1B 2D n
Turn underline mode on/off There is no thickness option available. A
1B 44 m1...nk 00
Set horizontal tab positions The number of tab positions is limited to
1B 63 34 n
Select paper sensor to stop
printing
1B 74 n
Select character code table All characters on all code pages are not
1D 5E r t m
Execute user-defined
message
1D 77 n
Set bar code width
1C 67 31 m a1 a2
Write to user NV memory
a3 a4...
1C 71 n [xL xH yL
Define NV bit image
yH...
Description of Limitation
A status byte will be returned when the
command is sent. The following status
bits will not be supported.
v Offline status bit 6
v Error status bits 5 and 6
v Paper roll status bits 2 and 3 (near
end of paper) - Bit will be set when
out of paper
value of n=1, 2, 49 or 50 will enable
underline mode.
5.
The command will be accepted, but it
has no function. There is no paper low
sensor on the SureMark. The printer will
only return out of paper status.
supported. The Katakana code page is
not supported.
Does not support the mode where the
user-defined message is printed when
the paper advance button is pressed.
The maximum width is 4 dots on the
SureMark. Widths of 5 and 6 will be
forced to 4 dots.
If received during user-defined message
definition, this command will be
embedded in the NV memory. Epson
will stop the definition and store the
data in NV memory.
The user is required to erase the NV
memory before the address can be
overwritten.
The width is limited to 576 dots wide
and 255 rows high.
Appendix G. Emulation support for Epson single-station printer
195
Advertisement
Table of Contents
