Table of Contents
Advertisement
Updated April 2, 2009
Figure 43. Offline printer test pattern (Models TF6 and TM6)
Test Pattern Notes:
1. The serial number that prints will be the actual serial number of your printer. (If
2. The microcode level will be the actual level of your printer's microcode.
3. The serial interface will be specified as EIA-232, RS-485, or USB, depending on
4. The line speed information appears only when the EIA-232 interface is used.
5. The EIA-232 control mode information appears only when the EIA-232 interface
6. The feature-enabled lines will appear only when a feature is installed.
7. This section contains the test pattern.
8. This section contains printer usage statistics that you can use for problem
9. The line across the bottom should be solid with no blank spaces.
EIA-232 hex dump
An EIA-232 hex dump is provided to help diagnose problems with Models TM6 and
TF6.
To enable hex dump mode for the Model TF6 or TM6 printer:
Power off the printer, press and hold the paper feed button and then power on the
printer with the paper feed button still pressed.
The Printers S/N is 12345678
Microcode EC level is 30
Serial Interface: RS232
Serial Interface
Serial Interface
: 19.2K Baud, XON / XOFF
|"#$%&'()*+,-./0123456789:;<->?ABCDEFGHIKJK
LMNOPQRSTUVWXYZ[\]^_ abcdefghijklmnopqrstuvw
xyz{|}~.CüéâäàåcêëèïîìÄÅÉæÆôöòûùÿÖÜø£ØSsáíóú
ÁÑGg¿ · · · · ¡ · ·
ÁÂÀ
H III · · · · · · · · · · · · · Ð
I
õ ÊËÈÍÎÏÌÓßOO õÕµþÞUUUyY±÷
Cuts:
12301
CR Characters Printed:
CR Motor Steps:
CR Cover Openings:
CR Cut Fails:
7
the logic card has been replaced, this number must be reset to the original
serial number.)
which interface is used to attach the printer to the system unit.
The value can be either 9.6 K Baud or 19.2 K Baud, depending on the EIA-232
switch settings. See "EIA-232 communication mode selections (all models
except TI8, TI9, TG8, TG9)" on page 28.
is used. The value can be either DTR/DSR or XON/XOFF, depending on the
EIA-232 switch settings. See "EIA-232 communication mode selections (all
models except TI8, TI9, TG8, TG9)" on page 28.
determination.
·
I
¢ · · · · · · · · ãÃ
^
`
` ^
77626
88974
40
Chapter 7. Testing and problem analysis (Models TF6 and TM6)
1
2
3
4 5
6
7
·
`
` `
·
8
9
,
77
Advertisement
Table of Contents
