Specifications - Hd 26T21 Mmd-Xxx-Fxxx - Hatteland HD 12T21 User Manual

Specifications - HD 26T21 MMD-xxx-Fxxx

SPECIFICATIONS
TFT Technology:
• High Quality TFT with CCFL Backlight
• 25.54 inch viewable image size, Widescreen, Aspect Ratio 16:10
• S-MVA, Active Matrix, Thin Film Transistor (TFT)
• RGB Vertical Stripe
TFT Characteristics:
• Native Resolution : 1920 x 1200
• Pixel Pitch (RGB) : 0.2865 (H) x 0.2865 (V) mm
• Response Time : 8 ms (typical), "gray" to "gray"
• Contrast Ratio : 1500:1 (typical)
• Light Intensity Standard : 350 cd/m
• Light Intensity High Bright : TBD
• Viewable Angle : +/- 88 deg. (typical) (Up/Down/Left/Right)
• Active Display Area : 550.08 (H) x 343.8 (V) mm
• Max Colors : 16.7 million
Synchronization:
• Digital separate synchronization
• Composite synchronization
• Synchronization on green
• Auto detects VGA -> WUXGA, interlaced and non interlaced
• Video Signal : Analog RGB 0,7Vp-p
: Input Impedance 75 Ohm
Synchronization Range:
• Horizontal : 31.5 kHz to 91.1 kHz
• Vertical : 60 Hz* to 85 Hz
* Recommended for optimal picture quality
Supported Signals:
Resolutions:
• VGA : 640 x 480 (including 640 x 350)
• SVGA : 800 x 600 (including 720 x 400)
• XGA : 1024 x 768
• SXGA : 1280 x 1024
• UXGA : 1600 x 1200
• FHD : 1920 x 1080
• WUXGA : 1920 x 1200*
* Recommended for optimal picture quality
Video Signals:
• Interlaced HDTV, NTSC, PAL and SECAM video
• Composite video
Power Specifications:
Multi-power Supply:
• 115&230VAC - 50/60Hz + 24 VDC
Note: You may connect either AC power or DC power or both. In case both sources
are connected, power will be sourced from the AC input. If AC input is lost, there will
be a uninterrupted switch-over to DC input.
Power Consumption:
• Operating AC/DC: 107W (typ) - 125W (max)
For a full overview of typenumbers, please review the following link:
www.hatteland-display.com/pdflink/ind100780-3.php
This product have been tested / type approved by the following classification societies: (*=pending)
IEC 60945 4th (EN 60945:2002)
DNV - Det Norske Veritas
LRS - Lloyd's Register of Shipping*
IND100129-154
Note: All specifi cations are subject to change without prior notice!
Please visit www.hatteland-display.com for the latest electronic version.
2
(typical)
- HD 26T21 MMD-Mxx-Fxxx
A P P R O V A L S
IACS E10
ABS - American Bureau of Shipping
All specifications are subject to change without prior notice!
Physical Considerations:
• 621.00 (W) x 435.00 (H) x 98.20 (D) mm
• 24.45" (W) x 17.13" (H) x 3.86" (D)
• 4 x M6 VESA mounting 280x150mm, Max 12mm deep
• Weight: 14.8kg / 32.6lbs
Signal Terminals:
• DVI-D Signal IN : 2 x 24p DVI (female)
• RGB Signal IN : 2 x 15p HD D-SUB (female)
• Comp. Video IN : 3 x BNC Connector (female)
• SCOM RS-422/485 : 1 x Phoenix Terminal Block 3.81, non-isolated+Buzzer
• RGB Signal OUT : 1 x 15p HD D-SUB (female) - Clone of RGB IN*
• If Touchscreen : 1 x USB TYPE A Connector (female)
• Ethernet : 1 x RJ45 Connector for Remote Control
• SCOM RS-232 : 1 x 9p D-SUB (female) non-isolated
• Potmeter : 1 x 9p D-SUB (male)
(Potentiometer IN, +5VDC OUT, BRT +/- IN)
• AC Power IN : 1 x Std IEC Inlet
• DC Power IN : 1 x 2p Phoenix MSTB 2,5/2-GF-5,08 THT
*Tested at recommended resolutions. The RGB output signal is at same resolution and
sync as the RGB input. The output is working even if the display unit is turned off, but
power cable/supply must be connected/provided.
User Controls:
Behind front bezel - Glass Display Control™ (GDC) IP66:
• Power On/Off, On Screen Display Menu, Brightness Control (-/+)
• Hotkeys (left/right), Mode Status Indicators (ECDIS, Service)
• Buzzer (not visible), Light Sensor (not visible)
Environmental Considerations:
• Operating : Temperature -15 deg. C to +55 deg. C
- Humidity up to 95%
• Storage : Temperature -20 deg. C to +60 deg. C
- Humidity up to 95%
• IP Rating : Protection: IP66 front – IP22 rear (EN60529)
• Compass Safe Dist. : HD26T21MMD-xxx-Fxxx - Std: 130cm Steering: 70cm
Safety Considerations:
Even although the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
Available Accessories:
• HD CMB SX1-C1 = 1 x Console Mount Kit
• HD TMB SX1-C1 = 1 x Table Mount Bracket. EN60945 Tested
Please see user manual/datasheet for more information
Factory Options:
• Capacitive Touch Screen (USB
• Optical Bonding Technology
• Sunlight Readable / High Bright (includes Optical Bonding)
• Color Calibrated models (ECDIS)
• Single AC Power 115&230VAC - 50/60Hz Input
* Release date to be con rmed. Please contact us for more information.
& C E R T I F I C A T E S
ClassNK - Nippon Kaiji Kyokai*
CCS - China Classification Society*
63
interface)*
model*
GL - Germanischer Lloyd
BV - Bureau Veritas
2/2