Table of Contents
Advertisement
OSD Menu Functions
Management Settings
Allows you to adjust overall settings for interaction/communication for the unit, such as scaling, zoom,
timing of signals, adjust voltages for LED (which illuminate the front glass symbols), sensitivity for the touch
control, VGA filter and Serial/Ethernet communication and more. The contents of these submenus are listed
below.
Management Settings
|---2---
Allow to scale the currently displayed full screen signal in various ways. The contents of the
submenus is listed below.
Management Settings - Graphic Scaling
|--------3--------
All scaling will performed from center of active display area and outwards in all directions.
Settings as follows:
Management Settings - Scaling
|--------3--------
All zooming will performed from center of active display area and outwards in all directions.
Settings as follows:
User Controls
IND100064-38
- Graphic Scaling
"Fill Screen"
"Fill to Aspect Ratio" = Zoom current full screen signal to fill the entire active display
"1:1"
"Zoom"
● Note: Values under or over 50, may cause blurry and unfocused imagery, since it overrides the
external signal's 1.1 pixel information and properties. Default value is 50.
- Scaling
= Zoom current full screen signal to fill the entire active display
area. Aspect ratio is ignored, which means that picture may
appear distorted or stretched.
area and preserve the aspect ratio. This means that you may
notice black bars without any image information either on
top/bottom or left/right of the centered image.
= Zoom current full screen signal to fill the entire active display
area as 1:1 native pixel resolution. Example; if the incoming
signal is a 800x600, on a 1600x1200 unit, the incoming
signal will be shown 50% less in size and centered on
screen. Aspect ratio is kept unchanged.
- Zoom
= Zoom the current full screen signal horizontally and vertically
in equal steps. Values from 0 to 100.
48
*Available in "Full Mode" only
Advertisement
Table of Contents
