Table of Contents
Advertisement
Installation Procedures
Note: Some units may have Single Key Hole, whilst others have Double Key Hole.
This is due to slight variation in initial production vs Mass Production throughout
2012. During early 2013, all units will have Double Key Hole.
5: Ensure that both Key Hole Plugs slide into the Key Holes and goes to the bottom position (FIG1 and FIG2). If they
appear too tight, you may loose the Key Hole Plug screw a few turns and re-try (see previous step 2). FIG3 shows
Key Hole Plug correctly into Key Hole and both brackets in place.
FIG1
6: Tighten Key Hole Screw firmly on each side and
make sure the brackets are properly mounted and
aligned to the main chassis of unit. Verify with your
hands that both brackets are firmly attached.
8: You may now mount the unit onto your desired location. It is advised that you unlock the Lock Pin (as shown in
step 7), tilt the unit 90 degrees backwards (FIG1) and properly fasten the bracket base into location (FIG2).
NB! Be careful not to break or scratch the edge of the front glass! Then repeat step 7 again until your desired
tilting position has been achieved and you have verified that the Lock Pin are in locking position and the unit is firmly
attached and does not appear loose (FIG3).
FIG1
Unlock, tilt and lock
Installation
IND100078-34
FIG2
7: While unit is lying flat on table, check the Tilting Lock Pin
position. These can be pulled out by hand, turned 90° (FIG1)
and turned back 90° until the Lock Pin automatically clicks into
place by a spring (FIG2).
FIG1
FIG2
Use appropriate fasteners
6 pcs x M6 needed
19
FIG3
Top View
Re-check Lock Pins!
2012
2012 / 2013
FIG3
FIG2
Locked
Unlocked
FIG3
Advertisement
Table of Contents
