Table of Contents
Advertisement
Installation Procedures
Mounting Bracket for Table / Desktop installation - 12",15",17",19"
You need: M4, M5, M10 Unbrako® Hex Key tool, M10 Wrench and 1 pcs of HD xxBRD SX1-A1 Mounting Bracket Kit,
where xx=12, 15, 17 or 19 inch. Fasteners (6 pcs M6) for Table / Desktop location not included.
Procedure suitable for: Display and Panel Computers Series X range.
Attention: A suitable pre-drilled location and knowledge of measurements for both main unit and
brackets/tilting functionality should be prepared and checked prior to mounting. Please disconnect
ALL cables before proceeding. Please review User Manual or visit www.hatteland-display.com for
Technical Drawings regarding measurements for both main unit and Mounting Brackets.
1: Place the unit on a dry, flat, clean, soft surface
(i.e. table) with the glass front facing down as
illustrated. Connector area should be facing
downwards from you.
Seen from
above
Connector Area
3: Verify that the Key Hole Set Screw (M4) is aligned
with the bracket surface (FIG1). If this screw appear
too far out (FIG2), proper fitting into the Key Hole
can not be completed. Turn screw clockwise or anti-
clockwise (FIG3) to adjust the position.
FIG2
FIG1
Wrong
Correct
Bracket Surface
Installation
IND100078-34
2: Inspect the inner side of both brackets and especially the
orientation of the Key Hole Plug (4 pcs). They should be
shaped as an standing "egg" to ensure proper fitting in the
Key Hole of unit (FIG1). Note: You may have to loose the
fastening screw (M5) (FIG2) if the Key Hole Plug can not be
turned by hand.
Wrong Correct
4: Notice the indication of LEFT and RIGHT. The mounting
bracket (2 pcs) is marked with respective stickers (L/R) from
factory. Please make sure that LEFT bracket is positioned on
LEFT side and RIGHT bracket is positioned on the RIGHT
side as shown below.
FIG3
Adjust
LEFT
18
FIG1
FIG2
Adjust
RIGHT
Advertisement
Table of Contents
