Assembly - Hiniker C-PLOW 8801 Operator's Manual

16 Plow Assembly
Remove the 1/2 inch hex bolt and spacer
from between the tabs on the push frame.
Slide the stop plate onto the bolt, as shown
in the drawing, then bolt the two lower links
inside the tabs, with the spacer between the
links.
Assemble the two upper lift links outside
the lugs on the lift frame with a 3/4 inch x
4 1/4 inch hex bolt and nylon insert lock
nut.
Bolt the upper link spacer bushing between
the two upper links with the 1/2 inch hex
bolt and lock nut.
Place the flat washer and spacer bushing
from the stop plate kit onto the remaining
3/4 inch hex bolt, then complete the lift
mechanism assembly by bolting the lift cyl-
inder rod, lower links and two shim washers
between the upper links.
Bolt through the upper set of bottom holes
in the upper links for most vehicles, then
secure the assembly with the 3/4 inch lock
nut from the stop plate kit. Bolting through
the lower set of holes will increase down-
ward plow travel for taller trucks, but reduce
lift height.
Rotate the stop plate up to contact the spac-
er bushing on the lift cylinder bolt. Gently
push back on the upper lift frame tube, then
release to allow the weight of the frame to
lock the stop plate in place.
5.
Drive the spring pin from the chamfered end of
pin #7 in drawing 5472, then remove the pin and
three spacers.
Extend the rollover cylinder until holes in the
two inner links can be assembled to holes in the
moldboard ribs.
6.
DWG NO. 6004
Snip the three plastic tie straps holding the
rollover cylinder and links to the back of the
moldboard assembly.
Pin the inner set of links between the ribs,
with the long spacer between the two links
and a short spacer between each link and
rib. Reinstall the spring pin to secure the

assembly.

Drive the spring pin from the chamfered
end of pin #8, then remove the pin and the
spacer.
Assemble the outer set of links between the
two frame plates, with the spacer installed
between the two links. Reinstall the spring
pin to secure the assembly.
Before assembling the power unit on the lift
frame, scrape a small amount of paint from
the two mount holes in the lift frame to pro-
vide a good electrical ground for the turn
signals and parking lights.
DWG NO. 5472