Hiniker C-PLOW 8801 Operator's Manual page 10

8 Operating Procedures
NOTE: The plow control box must be in the
"Float" mode to manually retract the cylinder
rod. If the cylinder rod cannot be retracted with
power on and the controller in float, loosen the
packing nut on the lift cylinder up to 1-1/2 turns
to reduce friction.
Retract Cylinder With Upper Lift Links
With the plow lowered to the ground and the
controller in the "float" mode, push down on the
upper lift links to fully retract the lift cylinder rod.
Retracting the lift cylinder will orient the prong
receivers correctly for reattaching the plow later.
Failure to retract the lift cylinder rod will allow
the lift frame to fall forward, possibly causing
personal injury or damage to plow components.
Rotate the stop plate up to contact the spacer
bushing on the lift cylinder bolt.
Rotate Stop Plate
Gently push back on the headlight bracket to
tilt the lift frame back as far as possible, then
release the bracket to allow the weight of the lift
frame to lock the stop plate in place.
Push Lift Frame Back
Swing the latch handle open until the latch
sliders are fully removed from the attachment
prongs.
DWG NO. 6000
Swing Handle To Remove Sliders
Lower the parking stand to the ground by re-
moving the tab lock pin from stand index plate,
then swinging the stand to the ground with the
lever.
DWG NO. 6004
Lower and Pin Parking Stand
Reinstall the pin in the index plate through the
hole in the lever to hold the stand in place.
DWG NO. 6005
DWG NO. 3856
DWG NO. 5251A