Hiniker C-PLOW 8801 Operator's Manual page 21

receptacles and one wire with a ring terminal.
NOTE: To prevent corrosion lightly coat all elec-
trical connections, rings and spade terminals
with dielectric grease prior to assembly.
Attach the ring terminal of the solid red (or
red striped) wire of the power cable assem-
bly to the terminal on the power unit at loca-
tion 1 in drawing 6468.
Locate the coil ground harness in the power
unit box. Connect the harness to the coils
as shown in drawing 6468.
Fasten the ring terminal of the solid black
wire of the power cable assembly, the black
wire with the ring terminal on the plow har-
ness and the ring terminal of the coil ground
harness to the terminal on the motor at lo-
cation 2.
Connect the Tan wire of the plow wiring har-
ness to the spade terminal on solenoid S1.
DWG NO. 6468
DWG NO. 6466
Connect the Gray wire to solenoid S2.
Connect the Brown wire to solenoid S3.
Connect the Pink wire to solenoid S4.
Connect the Blue with White Stripe wire to
solenoid S5.
Connect the Blue wire to solenoid S6.
Connect the RH headlamp to the har-
ness end labeled "PSNGR SIDE" and the
LH headlamp to the end labeled "DRIVER
SIDE".
Ensure connections are fully mated for
proper sealing. There should be no gaps
between connector halves. Secure these
cables to the frame with plastic ties.
Band the plow wiring harness to the frame
tube with a plastic tie strap, as indicated in
the drawing 6464 at location 3. Refer to the
drawing for routing wires to the power unit
and headlamps.
NOTE: Install the plow harness so that wa-
ter does not run down the wires and pool
inside the "Y" connection. Position the har-
ness so that any trapped water can easily
drain away.
Plow Assembly 19
DWG NO. 6464