Hiniker C-PLOW 8801 Operator's Manual page 22

20 Plow Assembly
Truck Battery On Passenger Side
WARNING: Disconnect truck battery be-
fore beginning electrical installation to
avoid shock hazard.
The motor solenoid, underhood wiring harness,
power cable and joystick control box are located
in the parts box shipped with the snowplow frame.
NOTE: Lightly coat electrical connectors, ring and
spade terminals with dielectric grease before in-
stallation to prevent corrosion
9. Refer to drawing 6474. Lay the harness in
it's approximate position for final assembly.
Position the 7-pin and 3-pin circular connec-
tors near the drivers side firewall, the 10-pin
and 3-pin connectors just left of center near
the grill, the relays near the drivers side inner
fender and the 5-pin headlight connectors at
the respective headlights.
10. Determine the location of the vehicle battery. If
the battery is located on the right (passenger)
side or if there are two batteries configured
as a 12 volt system, then proceed to step 11.
If the battery is located on the left side of the
vehicle, then the wiring harness will need to
be modified, as follows.
DWG NO. 6474