Hiniker C-PLOW 8801 Operator's Manual page 23

Truck Battery On Driver Side
Refer to Drawing No. 6475.
Remove the tape from the Black corrugated
loom at the points shown. Locate the Orange,
Red, and two Black wires. These wires con-
nect to the battery and pump solenoid. Re-
move the four wires from approximately 33
inches of the loom, making sure the Red and
Black wires are long enough to connect to
the battery. Tuck these wires back into the
loom as shown in the drawing and retape the
loom.
11. If there is no access hole in the drivers side
firewall then drill a 1-1/8 inch diameter hole.
Route the 7-pin and 3-pin circular connectors
through the firewall into the cab compartment
and install the 4 inch grommet in the hole, if
required.
CAUTION: Ensure that the relays will
clear any hood lift/spring mechanisms
before installation.
12. Select an area near the drivers side fender for
the relays. Drill three 1/8 inch diameter holes
and secure the relays with #8 X 1/2 inch self-
tapping screws from the hardware bag in the
parts box.
13. Splice the red with white stripe wire to the
vehicle's switched 12 volt auxiliary electrical
circuit. This will prevent operation of the plow
without the vehicle key being on. This wire
controls the accessory relay that powers the
control joystick and solenoids.
14. Connect the joystick control box to the 7-pin
and 3-pin connectors inside the truck cab.
Secure the box at a safe location in the cab
with the strip of hook and loop fastener.
Plow Assembly 21
DWG NO. 6475