Hiniker C-PLOW 8801 Operator's Manual page 19

Mount the power unit on the lift frame with
two 3/8 inch x 3/4 inch hex bolts and two 3/8
inch lock washers. The plastic reservoir of
the power unit should be to the left side of
the plow.
Locate the five straight O-ring/flare hydrau-
lic fittings in the hardware bag. Install the
O-ring ends of the five straight fittings into
the five ports in the power unit.
Locate two 45 o O-ring/flare hydraulic fittings
in the hardware bag, and install them into
the ports of the angling cylinders so that the
flare ends are nearly parallel to the mount
lugs of the push frame.
Identify five hydraulic hoses in the parts
box. The two longest hoses measure 66
inches long, one hose is 54 inches long and
the two shortest hoses are 33 inches long.
DWG NO. 6463
DWG NO. 4205
The 54 inch long hose connects port A on
the power unit to the LH angling cylinder.
Connect the 90 o hose end to port A, then
route the hose along the cross brace at the
rear of the push frame before connecting
the straight end to the cylinder. Secure the
hose to the brace with plastic tie straps. Re-
fer to drawing 6465.
Connect one of the 33 inch long hoses be-
tween port B on the power unit and the RH
angling cylinder. Connect the last 33 inch
long hose between port E on the power unit
and the lift cylinder.
Strap the three hoses from the angling and lift
cylinders together with a plastic tie, as shown
in drawing 5661.
Plow Assembly 17
DWG NO. 6465
DWG NO.5661