Hiniker C-PLOW 8801 Operator's Manual page 20

18 Plow Assembly
Route the two 66 inch long hoses through
the hose loop on the push frame and ahead
of the lift frame tube so that the 90 o ends
are toward the power unit and the straight
ends are toward the rollover cylinder on the
back of the moldboard.
Assemble one of the hoses between port
C on the power unit and the rod end of the
rollover cylinder. Connect the last hose be-
tween port D and the butt end of the rollover
cylinder.
Band both hoses to the hole in the upper
plate of the push frame with a plastic tie
strap, leaving about 17" of hose between
the rod end cylinder port and the tie strap.
Also band the hoses together just ahead of
the first tie and just behind the hose loop.
7.
DWG NO. 6461
8.
DWG NO. 6462
Before assembling the headlamp brack-
ets on the lift frame tube, scrape a small
amount of paint from the three holes in each
bracket and from the four holes in the frame
tube to provide a good electrical ground for
the turn signals and parking lights.
Mount the headlamp brackets to the lift
frame tube with four 3/8 inch x 2 inch car-
riage bolts and flanged lock nuts from the
hardware bag in the parts box. Remove the
LH and RH headlamps from their boxes and
mount on the brackets with hardware from
the headlamp boxes.
Use plastic tie straps to band headlamp
cables above and below the brackets at the
locations shown to provide clearance for
the power unit cover later.
Refer to sections titled "System Check-Out"
and "Headlamp Aiming Procedure" in this
manual for aiming instructions.
Identify the plow power cable assembly and
the plow wiring harness in the parts box.
The power cable for the snowplow has two
cables with ring terminals on one end and
a two pin connector on the other, and mea-
sures about 38 inches long.
The plow wiring harness has a 10-pin con-
nector and a 3-pin connector on one end
and the other end has connectors labeled
"DRIVER SIDE" and "PSNGR SIDE" for the
headlamps, and six loose wires with spade
DWG NO. 6469A