Hiniker C-PLOW 8801 Operator's Manual page 17

Align the push frame hitch plates with the
pivot hole in the moldboard tube, then reas-
semble the 3/4 inch hex bolt, slotted nut and
cotter pin. Install the nut so that the assembly
is secure, but frames will pivot.
Reassemble the two 1/2 inch hex bolts, spac-
ers and lock nuts at their original locations
and fully tighten hardware.
Remove clevis pins from the rod ends of the
two angling cylinders. Loosen the plugs in the
cylinder ports and extend the cylinder rods to
the lugs on the back of the moldboard. Pin the
rods between the lugs with the clevis pins and
cotter pins.
3. Tip the moldboard and frame assembly to its
working position with a hoist or fork truck. Pin
the parking stand to hold the square tubes of
the push frame parallel to the ground.
Lower and Pin Parking Stand
Swing the lift frame up to its approximate
working position and hold it with a hoist or
forklift for assembly of the lift mechanism. The
bottom surface inside the two prong receiver
channels should measure approximately 10
4.
DWG NO. 5420A
DWG NO. 5251A
inches above the ground in the working posi-
tion.
Locate a 90 o O-ring/flare adapter in the hard-
ware bag and the lift cylinder in the parts box.
Turn the O-ring end into the port of the lift cyl-
inder so that the flare end is toward the rod
end of the cylinder when tightened.
Pin the base of the cylinder between the cen-
ter lugs of the lift frame with the 3/4 inch x 3
inch clevis pin. The hydraulic fitting should be
on the right side of the cylinder.
Remove four lift links and the stop plate kit
from the parts box. From the hardware bag
remove two 3/4 inch hex bolts, two 3/4 inch
I.D. shim washers and one 3/4 inch nylon in-
sert lock nut. Also remove the 1/2 inch hex
bolt and upper link spacer bushing.
Identify the RH and LH upper and lower links
by referring to drawing 6585. Assemble the
links with their stop surfaces away from the
lift cylinder.
Plow Assembly 15
DWG NO. 4202
DWG NO. 6585