Hiniker C-PLOW 8801 Operator's Manual page 27

Check the oil level with the plow on the
ground and the blade uncurled. Add oil to
the fill line, if necessary, but do not over-
fill the reservoir.
NOTE: New hydraulic lift and angle cylinders will
leak a small amount of oil until packings become
saturated and produce a good seal. If leakage
is excessive, or if leaking continues after initial
cycling, tighten the cylinder packing nut in 1/8-
turn increments until leaking stops.
24. Fasten the power unit cover to the lift frame
bracket with two 1/4" x 3/4" screws, flat
washers and lock nuts from the hardware
bag in the parts box. Tighten the lock nuts
so that the assembly is secure, yet the cov-
er hinges freely.
When the cover is closed, rods from the latch
handles should extend behind the light brackets
to hold the cover in place.
25. Remove the 5/16" hex bolts and lock nuts
DWG NO. 6310
DWG NO. 6467
holding the side markers to the top of the
moldboard, and reassemble markers to the
end of the moldboard.
Plow Assembly 25
DWG NO. 5410