Hiniker C-PLOW 8801 Operator's Manual page 25

19. Locate three blue connector splices in the
hardware bag in the plow's parts box.
Using a blue splice, crimp the single brown
wire from the underhood harness into the
vehicle's driver's side parking light wire.
Using a blue splice, crimp the single yellow
wire from the underhood harness into the
vehicle's driver's side turn signal wire.
Using a blue splice, crimp the single green
wire from the underhood harness into the
vehicle's curbside turn signal wire.
20. Select the proper headlight adapter for your
21. Secure all cables away from hot or moving
22. At this point, the mount kit should be as-
DWG NO. 4165
vehicle, specific instructions are included
with each kit.
The headlight adapter kit consists of two
identical adapters. Install the adapters ac-
cording to the instructions included with the
kit and connect to the 5-pin connectors of
the underhood wiring harness.
components with cable ties.
This completes the Electrical Installation.
sembled onto the truck.
Prongs from the truck mount kit should be at
a height that will slightly lift the plow frame
when attaching the plow. Prong receivers
on the plow frame should be parallel to the
ground when attaching the plow.
Apply powdered graphite on the truck
prongs to help the plow to slide on and off
more easily.
Plow Assembly 23
DWG NO. 5295