Hiniker C-PLOW 8801 Operator's Manual page 26

24 Plow Assembly
Attach the plow onto the truck by driving the
truck prongs into the receivers on the plow
frame. Pull the latch handle into the frame
clevis to move sliders through the notches in
the prongs and receivers.
Pin the handle in the clevis with its klik pin.
Raise the parking stand to its highest position
and repin.
23. Select Hiniker Cold Flow Hydraulic Oil or
DWG NO. 4199
DWG NO. 5617A
DWG NO. 5232
Connect the three electrical cables from the
plow to their corresponding receptacles on
the truck.
an equivalent oil that meets military speci-
fication 5606, for plowing in extremely cold
temperatures.
Pour hydraulic oil into the power unit oil
reservoir until the oil level reaches the fill
level.
Before operating the plow for the first time,
be sure to remove the two bolts on the back
of the plow that prevent the moldboard from
curling.
Raise and lower the plow, cycle the an-
gling cylinders, and work the rollover
function of the plow to purge any air
trapped in the system.
DWG NO. 6470
DWG NO. 5474