Gige Output; Figure 1.6 - Camera Back Panel -Gige Output - Imperx BOBCAT User Manual

1.4.2 GigE Output

The interface between the GEV camera and outside equipment is done via 2
connectors and one LED, located on the back panel of the camera – Figure 1.6.
1. Camera output – standard RJ-45 provides data, sync, control, and serial interface.
2. 12-pin Power Connector – provides power and I/O interface.
3. Status LED – indicates the status of the camera – refer to Status LED section.
4. Serial Number – shows camera model and serial number.
The Camera data along with the serial communication and triggering signals are
serialized and continuously transmitted over the Gigabit Ethernet interface at GigE‟s
full 1-Gb/s line rate, while delivering consistently low, predictable latencies. The
network interface is compatible with IP/Ethernet networks operating at 1000 Mb/s
using standard LAN CAT-5 (CAT-5e) cables.
The power and all external input/output signals are supplied to the camera via the
camera power connector shown in Figure 1.5b. The corresponding pin mapping is
shown in Table 1.4a. The connector is a HIROSE type miniature locking receptacle
#HR10A-10R-12P. The power supply is shipped with a power cable which
Imperx, Inc.
6421 Congress Ave.
Boca Raton, FL 33487
+1 (561) 989-0006
Figure 1.6 – Camera back panel –GigE output
46 of 265
BOBCAT Hardware User's Manual
Rev. 2.0.6
11/20/2012