Table of Contents
Advertisement
Save To:
Boot:
DPM:
Imperx, Inc.
6421 Congress Ave.
Boca Raton, FL 33487
+1 (561) 989-0006
Saves the camera registers to File, User Space #1 or User Space #2.
Factory Space is disabled for regular users and it is available only for
manufacturing technicians.
1. File – saves the current camera settings to a configuration file
2. Factory Space – saves the current camera settings to the camera
Factory space. This is restricted command and is disabled for
regular users.
3. User Space #1 – saves the current camera settings to the camera
User space 1.
4. User Space #2 – saves the current camera settings to the camera
User space 2.
This menu selects the „Boot From‟ source. Upon power up, the
camera will load its registers from the selected „Boot From‟ source:
Factory, User #1 or User #2. Bobcat camera will be release with
„Factory" Setting and user can save and boot camera with their own
configurable features.
Defect Pixel Map – When selected, the DPM window will show
defected pixels location. The defective pixel map is stored in the
camera‟s non-volatile memory and read out when running bad pixel
correction – Figure 5.4. Defected pixels are categorized as:
Figure 5.4 – Defective pixel map
1. Dead Pixels – pixels with sensitivity that deviates more than
15% due to fluctuations in the CCD manufacturing process.
199 of 265
BOBCAT Hardware User's Manual
Rev. 2.0.2
11/20/2012
Advertisement
Table of Contents
