Imperx BOBCAT User Manual page 155

4.2.3.3 Error Code Description
To manage camera reliability, not-acknowledge error codes are defined as
follows:
x00 – No error
x01 – Invalid command. An invalid command (not 52 or 57) has been sent to
x02 – Time-out.
x03 – Checksum error
x04 – Value less then minimum
x05 – Value higher than maximum
x06 – AGC error
x07 – Supervisor mode error
x08 – Mode not supported error
Imperx, Inc.
6421 Congress Ave.
Boca Raton, FL 33487
+1 (561) 989-0006
the camera.
155 of 265
BOBCAT Hardware User's Manual
Rev. 2.0.2
11/20/2012