Table of Contents
Advertisement
Bit Depth:
Corrections:
Imperx, Inc.
6421 Congress Ave.
Boca Raton, FL 33487
+1 (561) 989-0006
2. Overclock – over-clocked camera operation. The camera
speed (frame rate) significantly increases while preserving
the image frame size noise and overall performance.
Lines – selects the size of the FVAL signal (valid lines in a
frame) and provides "Full size" or "Active size" options. Two
sizes (camera dependent) are available for selection.
Pixels – selects the size of the LVAL signal (valid pixels in a
line) and provides "Full size" or "Active size" options. Two sizes
(camera dependent) are available for selection.
Image – converts the image from positive to negative.
Sets the camera bit depth, and which bits to be used in the data
output.
Depth – sets the bit depth of the camera output to 8, 10, 12, 14 0r
3x8 bits. All internal camera processing is done in 14 bits. 14-bit
output is available ONLY in 1 Tap Single data format.
Shift – selects which part of the entire 14 bit internal data will be
mapped. This provides up to 7 bits digital shift left or right to
manipulate camera brightness and contrast. A graphical
visualization of the selected bits is shown in the center of the
window
DPC – enables Defective Pixel Correction (DPC). Each camera
comes with a built-in Defective Pixel Map (DPM) to correct for
defective pixels. The user can upload a custom DPM.
HPC – enables Hot Pixel Correction (HPC). Each camera comes
with a built-in Hot Pixel Map (HPM) to correct for hot pixels.
The user can upload a custom HPM
FFC – enables Flat Field Correction (FFC). Only big format
CCD cameras (optical format of 1") have this feature. Each
camera (when available) comes with a built-in Flat Field Map
(FFM) to compensate for shading effect intrinsic to the imager.
The user can upload a custom FFM.
221 of 265
BOBCAT Hardware User's Manual
Rev. 2.0.2
11/20/2012
Advertisement
Table of Contents
