Command Priorities In The Queue; Priority Levels - IBM Tape Library Magstar 3494 Operator's Manual

Command Priorities in the Queue

Priority Levels

|
|
|
|
54
Magstar 3494 Tape Library Operator Guide
The library manager manages the operations queue with a set of priority levels. The
library manager places operation requests in the queue in priorities from 0 through
9. A command priority of 0 is the highest priority and a command priority of 9 is the
lowest priority. The priorities are established so Mount requests take precedence
over any other operation, except for operations that must be executed on a priority
basis. Therefore, priority level 0 is reserved for internally generated operations,
while host requests start with priority level 1.
Higher priority operations are taken from the queue first. Within a priority level,
operations are taken first-in first-out (FIFO). (The order may be shuffled if
commands get requeued because something, such as an I/O station, may be busy).
Table 4 shows the priority levels, the operations in each level, and the operations
that the operator can promote to priority 2. The highest priority that an operator can
promote a queued operation is Level 2.
Note: If a priority 3 operation is in the queue for a specified period of time, it is
automatically promoted to a priority 2. This prevents priority 3 mounts from
being "blocked out" by higher priority operations.
Table 4. Command Queue Priorities
Priority Operations
0 Inventory update
1
v Mount from category
v Mount from input station operations
v Mount cleaner cartridge
v Export
v Import
2
v Promoted by operator
v Logical Mount - category or specific
3 Mount specific volser
4
v Move cartridge from input station
v Unlabeled tape operations
v Eject volser
5 Audit volser
6 Reserved
7 Demount
8 Reserved
9 Offline command
For details on Mount Operations, Demount Operations, and Audit Operations, see
"Host-Initiated Operations" on page 55.
Promotable
—
—
—
Yes
Yes
Yes
—
Yes
—
—