Table of Contents
Advertisement
|
Table 44. Import Status Messages (continued)
| |
Message Code
Message Text
| |
I0013
IMPORT PROCESSING RESUMED, SCRATCH VOLUME MADE AVAILABLE
|
This message is generated when, after the import operation was suspended because no scratch
|
stacked volumes were available, scratch stacked volumes are again available and the import
|
operation can continue.
|
Action: None, status only.
| |
I0014
IMPORT PROCESSING TERMINATED, WAITING FOR SCRATCH VOLUME
|
This message is generated when the VTS has terminated the import operation because scratch
|
stacked volumes were not made available to the VTS within 60 minutes of the VTS need for a
|
scratch volume on which to copy imported logical volumes.
|
Action: Operator should make more VTS stacked volumes available, perform analysis of the
|
Status File on the Export List volume, and reissue the Import operation.
| |
I0015
IMPORT RECOVERY STARTED
|
The Import operation has been interrupted by a VTS error or a power off condition for which
|
recovery is being attempted.
|
Action: None, status only.
| |
I0016
IMPORT RECOVERY COMPLETED
|
The recovery attempt for interruption of an Import operation has been completed.
|
Action: Perform analysis of the Status File on the Export List volume and reissue the Import
|
operation, if necessary.
|
Export/Import List Volumes Failure-Reason Text
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Table 45. Export-Import List Volumes Failure Reason Text
|
| |
Failure-Reason Text — Probable cause.
|
|
Volume <VOLSER> has not been written
|
|
The Export or Import operation specified a Export/Import
|
|
List Volume which has not been created (written).
|
If the VTS subsystem was unable to process the Export or Import list volume, the
host generates message CBR3858I. The reason the list volume could not be
processed is included as a text string. The following table defines the
failure-reasons returned, the probable cause and the recommended actions for the
customer to take.
In the table below, the symbols <VOLSER>, <File>, <Record>, and <Field> will be
replaced in the message text as appropriate to describe the location of the error
found:
v <VOLSER>, the logical Volser which was provided in the Export or Import
operation.
v <File>, Export List File, Import List File, Reserved File or Status File.
v <Record>, within a HDR1, HDR2, EOF1 EOF2, Identifier or Record.
v <Field>, within a Label Identifier, Block Count, Record Length, Block Count, Title
Text or Version.
Recommended Action
Operator should check for the correct identity of the
Import/Export List Volume and, if necessary, execute the
JCL which prepares a logical volume as the Import/Export
List Volume.
Appendix B. Virtual Tape Server Import/Export Advanced Function
331
Advertisement
Table of Contents
