Table of Contents
Advertisement
|
|
|
|
|
|
|
|
|
|
|
|
|
170
Magstar 3494 Tape Library Operator Guide
Select a type of inventory as follows:
v Inventory new storage (at subsystem installation time)
Note: Selecting inventory new storage causes any cartridges with unreadable
external labels to be ejected.
v Re-inventory the complete system (at any time)
Note: If Virtual Tape Servers are installed, see "Re-Inventory with Virtual Tape
Servers" on page 174.
Note: If Re-inventory Complete System is selected and there are VTS Import
or Export stacked volumes in the Unassigned, Import, or Export-Hold
categories, then the panel shown in Figure 100 will be displayed and the
operator will not be allowed to continue with the reinventory until the
Import/Export volumes are ejected from the library. The reinventory is
blocked to prevent the possible destruction of important Exported data.
The operator should exit this panel and then select the appropriate
panel(s) under the Commands pulldown under System Management on
the LM Operator Panel and eject the indicated volumes. When all the
Import/Export volumes are removed from the library, the operator can then
select Reinventory Complete System and continue.
Figure 100 shows the Display VTS Export/Import Volumes Window.
Figure 100. Display VTS Export/Import Volumes Window
Advertisement
Table of Contents
