Cr Scale - Epson L800 Service Manual

L800/L801

1.5.3 CR Scale

During the disassembly/reassembly of the Printer Mechanism,
C A U T I O N
take extra care not to touch the CR Scale with bare hands, and not
to contaminate or scratch it.
Removal procedure
See the section given below on how to unlock the carriage.
C H E C K
P O I N T
"1.1.6 How to Unlock the Carriage"
1. Unlock the carriage and move the CR Unit to the center.
2. Remove the Torsion Spring from the hook (
Frame.
3. Remove the CR Scale from the hook (
Frame.
4. Pull out the CR Scale from the slit of the CR Unit.
5. Turn the CR Scale 90 degrees in the direction of the arrow, and remove the
CR Scale from the hook.
Extension Spring
Hook
Turn 90°
Figure 1-55. Removing the CR Scale
Disassembly/Reassembly
) on the left side of the Main
) on the right side of the Main
Slit
CR Scale
Install the CR Scale with its cut-corner facing upward. Hitch one end
of the Torsion Spring to the hole of the CR Scale from the back side of
the CR Scale.
Hitch from the back side
CR Scale
Figure 1-56. Reinstalling the CR Scale
Revision A
Cut-corner
Hook
40
Confidential