Joint; Cover Case - Epson L800 Service Manual

L800/L801

1.6.8 Joint

Front
Adapter Side
Joint
Joint

Cover Case

Ink Supply Tube
Make sure the red lines of the Ink Supply Tank Tube and Ink Supply Tube facing
upward.
When attaching the Joint, align the cutout of the Joint with the rib of the Cover Case.
Make sure the gaps between the end of Ink Supply Tank Tubes or Ink Supply Tubes
and the Joint are 0.5 mm long or less.
Disassembly/Reassembly
Back
Tank Side Tank Side
Adapter Side
Joint
Ink Supply Tube
0.5 mm or less
Joint
0.5 mm or less
Ink Supply Tank Tube
Joint
Rib
1.6.9 Cover Case
Cover Case
Front Frame
Cutout
The location where Front Frame may interfere.
Be careful not to damage the Cover Case with the edges of the front frame.
Follow the procedure below when removing the Cover Case.
1. Remove the screw (x1).
2. Lift the Cover Case slightly to release the dowels (x2) on the bottom of the Cover
Case.
3. Rotate the Cover Case in the direction of the arrow (1) to avoid the section A and B of
the Cover Case from bumping against the Front Frame.
4. Remove the Cover Case in the direction of the arrow (2) while avoiding the section C
of the Cover Case from bumping against the Front Frame.
Joint
Front Frame
1
Cover Case
The location where Front Frame may interfere.
Section B
Section A
Dowel
C.B.P. 3X8 (5-7kgf.cm)
Revision A
2
1
Section C
Cover Case
65
Confidential