Epson L800 Service Manual page 60

L800/L801
When installing the Front Paper Guide Assy, pull out the CDR
Tray Sensor cable as shown below.
CDR Tray Sensor Cable
Figure 1-112. Routing the CDR Tray Sensor Cable
Attach the long foot of the EJ Ground Spring as follows; (1)
put it through the gap under the portion contacts with the EJ
Roller, (2) let it contact with the Main Frame, (3) let it contact
with the PF Roller shaft, (4) put it through the hole on the
frame. When finished, make sure the spring properly contacts
with (1), (2), (3), and (4) points.
Contacts with PF Roller Shaft
Contacts with EJ Roller shaft
Contacts with Main Frame
1
1
Figure 1-113. Attaching the EJ Ground Spring
Be careful not to deform the EJ Ground Spring.
Disassembly/Reassembly
[Left Front Bottom Side]
Pull out the cable
from here
Long foot of EJ Ground Spring
4
3
2
Hole
4
Gap
Front Paper Guide Assy
Place the four tips of the Front Paper Guide Pad on the Waste
Ink Pad.
[Bottom Side]
Tip of Front Paper
Guide Pad
Figure 1-114. Installing Front Paper Guide Pad
When installing Parallelism Bushing L, match the positioning
hole with the guide pin shown in
Whenever the Front Paper Guide Assy is removed or replaced, the
A D J U S T M E N T
R E Q U I R E D
required adjustments must be carried out.
Refer to "2.1.2 Required Adjustments" (p.74)
Revision A
Waste Ink Pad Position
Tip
Tip
Fig.1-108 (p.57).
Confidential
59