Epson L800 Service Manual page 34

L800/L801
When installing the Panel Unit, be careful of the following:
When installing the Panel Shield Plate to the Open Sensor
Holder, match the hook and guide pins with the positioning
holes shown in Fig.1-38
the groove of the Open Sensor Holder to secure the Panel
Shield Plate.
Open Sensor Holder
Figure 1-38. Installing the Panel Unit
Attach the Panel FFC with double-sided tape along with the
reference line shown in
When installing the Panel Board, match the guide pin with the
positioning hole shown in Fig.1-36.
Install the PS button, Ink button, and Paper button as shown
in Fig.1-37.
Disassembly/Reassembly
and insert the Panel Shield Plate into
[Upper Side]
Panel Shield Plate
Guide Pin and Positioning Hole
Hook and Positioning Hole
Groove
Fig.1-35 (p.32).
Panel Assy/ Cover Open Sensor
Cover Open Sensor Removal
1. Remove the Panel Assy. (p.30)
2. From the back of the Open Sensor Holder, disengage the hook of the Cover
Open Sensor, and remove the Cover Open Sensor pulling its rib out of the
hole by rotating the sensor in the direction of the arrow.
3. Disconnect the connector from the Cover Open Sensor to remove the Cover
Open Sensor.
[Back Side]
Hook
Rib
Figure 1-39. Removing the Cover Open Sensor
When installing the Cover Open Sensor, insert the rib shown in
Fig.1-39 into the hole of the Open Sensor Holder, and secure the
Cover Open Sensor with the hook.
Revision A
Cover Open Sensor
Connector
Open Sensor Holder
33
Confidential