Left & Right Guide Stackers / Cdr Guide Sensor - Epson L800 Service Manual

L800/L801
1.5.7 Left & Right Guide Stackers / CDR Guide Sensor
Removal procedure
Be careful of the seven sharp edges shown in
C A U T I O N
assembling or reassembling.
Left / Right Guide Stacker Removal
1. Remove the screw and remove the Left Guide Stacker.
Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm)
2. Remove the screw and remove the Right Guide Stacker.
Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm)
Left Guide Stacker
Left Guide Stacker
Sharp edge
Figure 1-66. Removing the Left / Right Guide Stacker
Disassembly/Reassembly
Fig.1-66 when
1.
Right Guide Stacker
Left & Right Guide Stackers / CDR Guide Sensor
When installing the Left Guide Stacker, insert the rib indicated
with in Fig.1-67 and match the positioning holes and guide
pins indicated with
When installing the Right Guide Stacker, match the
positioning holes and guide pins indicated with
pairs) in Fig.1-67.
Left Guide
Stacker
Figure 1-67. Installing the Left / Right Guide Stacker
CDR Guide Sensor Removal
Disengage the two hooks on the back of the CDR Guide Sensor and remove
the CDR Guide Sensor.
Right Guide Stacker
CDR Guide Sensor
Figure 1-68. Removing the CDR Guide Sensor
Revision A
(two pairs).
(two
Right Guide
Stacker
[Back Side]
Hooks
Confidential
44