Table of Contents
Advertisement
this parameter is 9600 . Make sure that your terminal emulator baud rate matches
the console baud rate you set.
Creating a Console Session Using a Modem
Use the Serial Link Configuration menu to configure the switch in order to
communicate with a console via a modem.
Set your modem according to the table below.
Setting
Echo
Result codes
Wait for connection
Pause between calls
Drop DTR between calls
Send CR between calls
Auto baud detect
Send init if CD high
Maximum dial attempts
Table 12. Modem Settings
Caution: Some modems use slightly different names for the options. It is important
that your modem be configured correctly. The settings shown in italics are
particularly important. If your modem is not configured correctly, the connection
may cause the switch to reset.
Start the console by pressing
the console to terminate the Telnet session and press
console session.
Stopping the Console Session
Pressing
CTRL-P
returns to the greeting menu.
B
CrossFire 8730 Switch Reference Guide, DOC-7047 v. 1.1
Off
Off
45 seconds
6 seconds
Yes
Yes
On
Yes
999
ENTER
returns the console session to the main menu, and pressing
Value
. If a Telnet session is active, press
ENTER
119
at
ENTER
again to start the
CTRL-
Switch Configuration
Advertisement
Table of Contents
