Ignition Cut-Off; Riding Your Scooter - KYMCO Xciting 250i Owner's Manual

OPERATION
8. Allow the engine to warm up fully before riding.
Do not "BLIP" the throttle (opening it and closing it rap-
idly) as the scooter will move forward suddenly.
Do not leave the scooter unattended while the engine is
warming up.
Ignition cut off
(Xciting 250i/Ri, 300i/Ri & 500i/Ri models)
These versions of the Xciting scooter are designed to auto-
matically stop the engine and fuel pump if the scooter is tipped
over (a angle detection sensor cuts off the ignition system). If
your scooter has been tipped over, you must turn the ignition
switch to the OFF position and then back to ON to reset this
sensor before you can restart the engine.
Riding
NOTE: After starting, allow the engine oil to circulate be-
fore riding your scooter. Allow sufficient idling time after
warm or cold engine start up before applying load or rev-
ving the engine. This allows time for the lubricating oil to
reach all critical engine components.
NOTE: Review the scooter safety recommendations on
pages 6 and 7 before you ride.
Make sure flammable materials such as dry grass or
leaves do not come in contact with the exhaust system
when riding, idling, or parking your scooter.
1. Make sure the throttle is closed and the parking brake 3
(Xciting 500i and 500Ri models) is engaged before moving the
scooter off the center stand. On other models, squeeze the left
brake lever as you move the scooter of f of the center stand.
3 3 3 3 3
37