Right-Hand Handlebar Switch - KYMCO Xciting 250i Owner's Manual

CONTROLS & FEATURES
Right handlebar switch
Headlight switch 1 1 1 1 1 "
The headlight and taillight will be lit.
" " position
The position light and taillight (running lamps) will be lit.
" " position
The headlight and taillight will be of f.
NOTE: Not all Xciting scooters have switches that control
the headlight circuit. Depending upon country and state
regulations, your scooter's controls may differ from the
switches described here.
20
1 1 1 1 1
2 2 2 2 2
" position:
Electric starter button 2 2 2 2 2 "
Press the electric starter button to activate the starter motor .
NOTE: The starter motor will not engage unless a brake
lever is squeezed at the same time the starter button is
pressed. Your scooter is also equipped with an safety in-
terlock that prevents the starter motor from being engaged
unless the sidestand is fully up.
To prevent damage to the starter motor, do not operate
the starter motor for more than five seconds at a time. If
the scooter fails to start immediately, check the fuel level
and the battery condition, and allow the starter motor to
cool before attempting to start the engine again.
Engine stop switch 3 3 3 3 3 "
The ignition circuit is off. The engine will not start or run.
":
4 4 4 4 4
3 3 3 3 3
" position: