Audio Volume; Display Version - Electronics Line Commpact User Manual

Audio Volume

To adjust the sensitivity of the microphone and the volume of the speaker:
1. Establish a two-way audio connection.
2. During the two-way audio session, from the Service menu, select Audio
Volume [708].
3. Adjust the setting according to the following table.
Reading
1
4
3
6

Display Version

To display the system's software version:
•
From the Service menu, select Version [710]; the software (SW) is
displayed.
Enable Programming
The engineer or the Central Station are able to establish remote connection to the control
system (using regular telephone, cellular communication, or through the Internet) in
order to check the system status, program the control system, and change its settings.
If Engineer Access is programmed as "user initiated" the engineer or the Central Station
cannot access the control system unless the Master User grants access with Enable
Programming command.
To give access to programming:
•
From the Service menu, select Enable Prog. [711]; a 30-minute time
window is opened during which the Engineer or RP gain access to the
control system programming.
Global Chime
Each detector can be programmed by your engineer to cause the system to chime when
activated. This feature is active only when the system is unset. For example, the system
can be programmed to sound a chime each time the front door is opened or closed. The
Global Chime option enables you to turn this feature on and off.
To enable or disable Global Chime:
1. From the Service menu, select Global Chime [712].
2. Select either Enable or Disable.
Global Chime can also be accessed via a convenient shortcut without needing to
enter a valid user code. To access the Global Chime option from Standby mode,
press then
30
Meaning
Increase microphone sensitivity
Reduce microphone sensitivity
Increase speaker volume
Reduce speaker volume
.
Advanced System Operation
7.
CommPact User Manual