Setting Tones; Remote Setting/Unsetting - Electronics Line Commpact User Manual

Setting and Unsetting
3.
Status
FULL SETTING
PART SETTING
PERIMETER SETTING
PART SETTING INST
PERI SETTING INST
The system may be programmed to display set status at all times or only for the
first two minutes or 30 seconds after you set or unset the system.
In addition to set status, the system displays messages on statuses that may prevent you
from setting your system (see the following table):
Status
ZONES IN ALARM
TAMPER ALARM
SYSTEM NOT READY
KEYPAD LOCKED
SYSTEM TROUBLE
3.5.

Setting Tones

Setting tones are the chimes that the system sounds during the entry/exit delay and
when the system sets or unsets. Various options are available that determine the
pattern of these tones.
Setting tones may be sounded by either the external wireless sounder or the control
panel's built-in sounder.
3.6.

Remote Setting/Unsetting

Remote Setting/Unsetting via SMS
You can set and unset the system remotely by sending SMS commands from a cellular
phone.
Each SMS command contains the following elements:
•
SMS Command Descriptor (up to 43 characters of free text)
•
# (separates the descriptor from the actual command)
CommPact User Manual
Meaning
The system is in the process of setting using the displayed
setting method (displayed during exit delay).
Meaning
Zones have been violated.
The system has been tampered with.
The system is not ready to set, check that all doors and
windows are closed.
Five unsuccessful attempts were made to enter a user
code; the keypad is locked for 30 minutes. If this
message appears, it is still possible to set/unset the
system using a keyfob. Setting is possible using a keypad
if one key setting is enabled.
A trouble condition has been detected, press
further details.
for
13