Audio Volume; Display Version - Electronics Line iconnect User Manual

Audio Volume

To adjust the sensitivity of the microphone and the volume of the speaker:
1. Establish a two-way audio connection.
2. From the Service menu, select Audio Volume [705].
3. Adjust the setting according to the following table.
Reading
1
4
3
6
Press √; the new settings are stored in the memory.
4.
GSM Signal Strength
You can measure the GSM signal strength.
To view the GSM signal strength reading:
From the Service menu, select GSM Signal [706]; the signal strength of
•
the cellular network is displayed.
Reading
8-9
5-7
Less than 5

Display Version

To display the system's software and hardware versions:
From the Service menu, select Version [707]; the software (SW) and
•
(HW) versions are displayed.
Enable Programming
The Enable Programming command allows a user to limit access to system
programming. It means that the installer or Remote Programmer can access the system
only after a user with Master code provides authorization using the Enable
Programming command.
To enable this feature, contact your installer.
To grant access to the installer or Remote Programmer:
From the Service menu, select Enable Prog. [708]; a 30-minute time
•
window is opened during which the Installer Code is valid or RP
communication may be established.
Meaning
Increase microphone sensitivity
Reduce microphone sensitivity
Increase speaker volume
Reduce speaker volume
Meaning
Reception is good
Reception is acceptable
Reception is unacceptable
-45-