Electronics Line Commpact User Manual page 42

To display the System Operation Area page:
On the Menu Bar, click Set/Unset. The System Operation page is displayed.
Figure 8: System Operation Area Page
Three setting modes are available: Full, Part and Perimeter. These modes enable you to
set your system accordingly to suit different circumstances.
Full Setting
Perimeter Setting
Part Setting
Before setting the system, check that all doors and windows are closed so that the system
is ready for setting. System status is displayed on the status bar at the bottom of the
page. If you are setting from a remote location and the system status is "Not Ready", you
may temporarily omit any zone that is causing this condition.
Unsetting can be regarded as turning the security system off. When the system is
disarmed only zones that are defined as active 24 hours (e.g. Flood, Gas and Panic
zones), or non-active zones for elderly care are monitored.
38
Full Setting activates the entire system. This setting method is
used when you intend to leave your home, leaving the premises
empty.
Perimeter Setting enables you to turn on the perimeter zones
(the windows and doors of your home) enabling you to move
freely within the protected area.
Part Setting enables you to set a section of your home while
remaining on a different part of the premises. For example, at
night your family is upstairs while the area downstairs is set.
Appendix B: Web User Application
CommPact User Manual