Electronics Line Commpact User Manual page 53

Appendix C: Glossary
Global Chime
Instant Set
Keyfob
LAN IP Address
Limited Code
Log
Master Code
Medical
Emergency
Message Center
Non-Controlled
Code
One-Key
Setting
Panic Alarm
Part Setting
Perimeter
Setting
PGM
Ready
Remote
Firmware
Update
Restore
CommPact User Manual
G
A feature that enables/disables the Chime feature for the entire
system – see Chime.
I
A setting method that cancels the entry delay after the system
has been Part or Perimeter set.
K
Handheld wireless transmitters used to remotely control the
system.
L
The address that your home router has assigned to the Control
System.
A user code that automatically expires 24 hours after it is
programmed.
See Event Log
M
The only user code with the ability to program other user codes.
The master code also has exclusive access to specific system
functions.
A type of alarm that informs the monitoring service that the user
is in need of medical assistance.
An optional feature that enables users to record messages to be
played back by other users.
N
A user code that does not cause the system to notify the
monitoring service when used to set or unset. The system only
reports if the code is used to unset after an alarm.
O
Setting the system without the need for a valid user code.
P
A user initiated event that alerts the monitoring service in the
event of an emergency.
A setting method that is designed to activate a certain section of
the premises.
A setting method that is designed to activate the detectors
protecting the doors and windows while enabling residents to
move freely on the premises.
Programmable output that is triggered according to specific
system status conditions, or by remote command sent via PSTN,
GSM, Ethernet, keyfob, keypad, or Remote Programmer.
R
The state in which all zones are closed and the system is ready to
be set.
Control System's firmware update from a remote PC using WEB
communication.
Restore of the normal state when the trouble is repaired. For
example, if AC power is reconnected, an AC Loss Restore event
code is sent to the central station.
49