Electronics Line Commpact User Manual page 54

Service Call
SMS Command
SMS
Confirmation
System Status
LEDs
Telecontrol
Tones
Trouble Tones
TWA
TX
TX List
TX Test
Un-omit
User Code
Walk Test
WUAPP
WAP
Web Remote
Programmer
Zone
Omit Zone
50
S
A feature that enables the user to contact the monitoring service
and talk to an operator via the Control System.
An SMS message sent to the Control System that causes the
system to perform a specific function.
An SMS message sent to the user confirming that the SMS
command has been performed.
Luminous indicators on the front panel that provide information
on the set and power status of the system.
T
A feature that provides remote access via the telephone including
remote setting/unsetting, sounder cancel and Two-Way audio.
A chime sounded by the Control System's internal or external
sounder.
Tones sounded by the system to indicate a trouble condition.
Two-Way Audio (abbr.)
Transmitter (abbr.)
A service feature that lists all the system's registered
transmitters, their last recorded status and signal strength.
A service feature that displays the source of the last received
transmission.
U
The restore of original state to an omitted zone.
A four-digit code that grants access to certain system functions
such as setting and unsetting the system.
W
A mode that enables detectors to be tested without generating an
alarm.
Web User Application Interface (abbr.) Web Application allowing
full interface to the system's user functions.
A protocol used to enable access to the mobile Web via mobile
phone or PDA.
Software that enable engineers or service providers to operate
and program the system from a PC either on-site or from a
remote location.
Z
A protected area within the security system.
See Omit Zone
Appendix C: Glossary
CommPact User Manual