Web Application Settings - Electronics Line Commpact User Manual

Appendix B: Web User Application

Web Application Settings

The Web Application Settings area offers various options including system/Web user
codes, contact and password management, user interface appearance and descriptors,
event log viewing and zone omit capabilities.
System Users and Codes
The System Users and Codes page enables you to manage your system's users. The page
displays a table of the system's current users and enables you add, edit and delete users
as required.
This capability is available only to a user with a Master code, the highest level of
authorization
The following System User types are available:
Master Code
(Code 1)
Controlled Codes
(Codes 2-19)
Non-controlled Codes
(Codes 20-25)
Limited Codes
(Codes 26-27)
Duress Code
(Code 28)
To display the System Users and Codes page:
1. On the Menu Bar, click Settings.
2. Click System Users and Codes. The System Users and Codes page is
displayed.
CommPact User Manual
The Master code is the highest user authorization level. With
the Master code, you can change all other user codes.
When you use a controlled user code for setting and unsetting,
the system notifies the monitoring service. You can assign
these codes to your children or employees whose comings and
goings are of interest to you.
Non-controlled codes do not cause the system to send
Set/Unset reports to the monitoring service. The system sends
a Unset report only if you use this code to unset the system
after an alarm occurrence.
A Limited code is a code that is valid for one day only. This
code automatically expires 24 hours after it has been
programmed. You can assign a limited code to a visiting guest,
for example.
The Duress code is designed for situations where you are
being forced to operate the system. This user code performs
the operation selected, while sending a Duress event message
to your monitoring service.
39