Web-Based Switch Configuration; Introduction; Logging In To The Web Manager - D-Link DGS-3600 Hardware Installation Manual

Hide thumbs Also See for DGS-3600:

Table of Contents

x Stack

Web-based Switch Configuration

Web-based User Interface

Web Pages

Introduction

All software functions of the xStack

Web-based (HTML) interface. Manage the Switch from remote stations anywhere on the network through a standard browser. The

browser acts as a universal access tool and can communicate directly with the Switch using the HTTP protocol.

The Web-based management module and the Console program (and Telnet) are different ways to access the same internal

switching software and configure it. Thus, all settings encountered in web-based management are the same as those found in the

console program.

Logging in to the Web Manager

To begin managing the Switch, simply run the browser installed on your computer and point it to the IP address you have defined

for the device. The URL in the address bar should read something like: http://123.123.123.123, where the numbers 123 represent

the IP address of the Switch.

This opens the management module's user authentication window, as seen below.

As there is no default User name or Password, click OK to proceed. This will open the Web-based user interface. The Switch

management features available in the Web-based manager are explained below.

DGS-3600 Series Layer 3 M anaged Gigabit Ethernet Sw itch

DGS-3600 Series switches can be managed, configured and monitored via the embedded

NOTE: The factory default IP address is 10.90.90.90.

Figure 5 - 1 Enter Network Password window

Section 5

Table of Contents