General Cleaning - LifeSpan Power User Manual

EVERY MONTH -IMPORTANT!
• Inspect all assembly bolts of the machine for proper tightness.
• Turn off the treadmill with the on/off switch, then unplug the power cord and wait 60 seconds.
• Remove the motor cover. Wait until ALL LED lights turn off.
• Clean the motor and lower board area to eliminate any lint or dust particles that may have
accumulated. Failure to do so may result in premature failure of key electrical components.
EVERY 6 MONTHS
It may be necessary to lubricate your treadmill running deck at least once every
six months to maintain optimal performance of your treadmill (refer to section
4.4 for information). Only use lubricant provided by Lifespan Fitness! Please
contact Lifespan Fitness with questions about applying lubricant to your
treadmill.
• Turn off the treadmill with the on/off switch, and then unplug the power cord at
the wall outlet.
• Loosen both the rear roller bolts. (For best results, place two removable marks
on both sides of the frame and note roller position).Once the belt is loosened,
take the bottle of lubricant and apply it to the entire top surface of the running
deck. Tighten both rear roller bolts (matching up the marks for proper position)
to original position. After you have applied lubricant, plug in the power cord, key,
start the treadmill and walk on the belt for two minutes to spread the lubricant.
• Lubricate the air shocks with Teflon based spray.
EVERY 2 YEARS
It is necessary that you change your treadmill motor brushes once every 2 years
to avoid damaging your motor. If you fail to change the brushes this may cause
the motor to burn out, voiding any warranty.
SERVICING: IF YOU FAIL TO COMPLY WITH LIFESPAN'S
SERVICING STEPS ABOVE, YOU MAY VOID YOUR WARRANTY. IF YOU REQUIRE A
SKILLED LIFESPAN REPRESENTATIVE TO UNDERTAKE ONE OF THE STEPS ABOVE,
PLEASE EMAIL US AT lifespanfitness@hotmail.com.

6.2 General Cleaning

Use a soft, damp cloth to wipe the edge of the belt and the area between

the belt edge and frame. A mild soap and water solution along with a nylon
scrub brush will clean the top of the textured belt. This task should be done
once a month. Allow to dry before using.
- 9 -
MAINTENANCE AND