LifeSpan Power User Manual page 6

（2）"on/off"
Under ready condition, press this key, it runs at the speed of 1.0km/h.
Under running condition, if it runs at speed more than 3.5km/h, it will slow
down then stop. During this stopping process, other keys are not available.
If it runs at speed less than
3km/h, then it stops immediately.
（3）"speed short cut key"
Under running condition, press this key, speed can be set to the value
directly.
（4）"incline up"
Press this key, you can choose the incline you need, except for the alarm
condition.
（5）"incline down"
Press this key, you can choose the incline you need, except for the alarm
condition.
（6） "select"
Under ready condition, press this key to enter "distance running" mode, it
has four kinds, U1~U4, under this mode, the treadmill will record your
total running distance automatically (minimum unit is 500m). And you also
can record it by press "clear/set" key after stop the treadmill, its minimum
unit is 100m. The records will remain after you shut off the power supply.
（7）"body fat"
Under ready condition, press this key to evaluate your body fat.
Press once, it will show SEX, press "speed up" and "speed down" key to
select.
Press this key again, it will show AGE, press "speed up" and "speed down"
key to select your age. (From 10~99years)
Press this key again, it will show HEIGHT, press "speed up" and "speed
down" key to select your height. (From 50~250cm)
Press this key again, it will show WEIGHT, press "speed up" and "speed
down" key to select your weight. (From 20~200KGS)
Then press "enter" key to get your Bodyfat.
Explanation:
Body fat < 19: too thin.
Body fat 19~25: normal
Body fat 26~30: overweight
Body fat > 30: fat
（8）"clear/set"
Under ready condition, press this key once, it will clear all the operation.
Under ready condition, press this key for 3 seconds continuously, time,
distance and calorie can be set. Press "speed-up" or "speed-down" keys,
time, distance and calorie can be set. Then press "on/off" key, the machine
will run at 1.0km/h. And the set figures will be counted down, when it
comes to "0", machine stops. Under running situation, press "reset/set", all
- 5 -