Figure 4-2 Menu 11.1 - Remote Node Profile; Table 4-1 Remote Node Profile Menu Fields - ZyXEL Communications Prestige 643 User Manual

Rem Node Name= ChangeMe
Active= Yes
Encapsulation= PPP
Multiplexing= LLC-based
Incoming:
Rem Login=
Rem Password= ********
Outgoing:
My Login=
My Password= ********
Authen= CHAP/PAP
The Remote Node Profile Menu Fields table, shown next, explains how to configure the Remote Node
Menu.
FIELD
Rem Node Name
Active
Encapsulation
Remote Node Configuration
Menu 11.1 - Remote Node Profile
Press ENTER to Confirm or ESC to Cancel:

Figure 4-2 Menu 11.1 - Remote Node Profile

Table 4-1 Remote Node Profile Menu Fields

This is a required field. Enter a descriptive name for the
remote node. This field can be up to eight characters.
This name must be unique from any other remote node
name or remote dial-in user name.
Choose Yes or No. Inactive nodes are displayed with a
minus sign (–) at the beginning of the name in Menu 11.
PPP refers to RFC-2364 (PPP Encapsulation over ATM
Adaptation Layer 5). If RFC-1483 (Multiprotocol
Encapsulation over ATM Adaptation Layer 5) of ENET
ENCAP is selected, then the Rem Login, Rem
Password, My Login, My Password, Edit PPP
Options and Authen fields are N/A. Moreover, ENET
ENCAP encapsulaton does not apply for IPX routing.
PPPoE (Point to Point Protocol over Ethernet) activates
the fields shown in the above figure.
Route= IP
Bridge= No
Edit PPP Options= No
Rem IP Addr= 0.0.0.0
Edit IP/IPX/Bridge= No
Session Options:
Edit Filter Sets= No
PPPoE Idle Timeout(sec)= N/A
PPPoE Service Name= N/A
Schedule Sets= N/A
DESCRIPTION
Prestige 643 ADSL Router
Enter a
unique name
of 8 or less
characters for
the Remote
Node Name.
Enter the IP
Address of
the Remote
Gateway
here.
EXAMPLE
Corp
Yes
ENET ENCAP
4-3