Static Route Setup - ZyXEL Communications Prestige 643 User Manual

Prestige 643 ADSL Router
FIELD
RIP Direction
Version
Multicast
IP Policies
Once you have completed filling in the Remote Node Network Layer Options Menu, press [
return to Menu 11. Press [
configuration or press [

5.1.2 Static Route Setup

Static routes tell the Prestige routing information that it cannot learn automatically through other means.
This can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is
directly connected to a remote node.
Each remote node specifies only the network to which the gateway is directly connected and the Prestige
has no knowledge of the networks beyond it. For instance, the Prestige knows about network N2 in the
following diagram through remote node Router 1. However, the Prestige is unable to route a packet to
network N3 because it does not know that there is a route through remote node Router 1 (via Router 2).
The static routes are for you to tell the Prestige about the networks beyond the remote nodes.
5-6
SPACE BAR
Press [ ] to select the RIP Direction. Choices are
Both, In Only, Out Only or None.
SPACE BAR
Press [ ] to select the RIP version. Choices are
RIP-1, RIP-2B or RIP-2M.
Choose IGMP-v1 (IGMP version 1), IGMP-v2 (IGMP version 2)
or None (disable IGMP). IGMP (Internet Group Multicast
Protocol) is a session-layer protocol used to establish
membership in a Multicast group.
Create policies using SMT Menu 25 (see IP Routing Policy) and
apply them on the Prestige LAN interface here. You can apply
up to four IP Policy sets (from 12) by entering their numbers
separated by commas.
ENTER
] at the message "Press ENTER to Confirm..." to save your
ESC
] at any time to cancel.
DESCRIPTION
Remote Node TCP/IP Configuration
EXAMPLE
None
RIP-1
None
(default)
3, 4, 5, 6
ENTER
] to