Figure 10-20 Option To Enter Debug Mode - ZyXEL Communications Prestige 643 User Manual

Prestige 643 ADSL Router
FIELDS
Initial Remote
Directory
Initial Local Directory
ftp> put P643.bin ras
This is a sample ftp session showing the transfer of the PC file "P643.bin" to the Prestige.
ftp> get rom-0 MyP643.cfg
This is a sample ftp session saving the current configuration to the PC file MyP643.cfg.
10.8.4 Boot Module Commands
When you reboot your Prestige, you will be given a choice to go into debug mode by pressing a key at the
prompt shown in the following screen. In debug mode you have access to a series of boot module
commands, for example ATUR (for uploading firmware) and ATLC (for uploading the configuration file)
already discussed in a previous section.
Bootbase Version: V1.05 | 4/14/2000 13:58:03
RAM: Size = 8192 Kbytes
FLASH: Intel 8M *2
ZyNOS Version: V2.50(AP.1) | 3/27/2001 15:42:40
Press any key to enter debug mode within 3 seconds.
.................................................
Enter ATHE to view all available Prestige boot module commands as shown in the next screen. ATBAx
allows you to change the console port speed. The x denotes the number preceding the colon to give the
console port speed following the colon in the list of numbers that follows; e.g., ATBA3 will give a console
port speed of 9.6 Kbps. ATSE displays the seed that is used to generate a password to turn on the debug
flag in the firmware. The ATSH command shows product-related information such as boot module version,
vendor name, product model, RAS code revision, etc. ATGO allows you to continue booting the system.
Most other commands aid in advanced troubleshooting and should only be used by qualified engineers.
10-18
DESCRIPTION
Specify the default remote directory (path).
Specify the default local directory (path).

Figure 10-20 Option to Enter Debug Mode

EXAMPLE
System Maintenance