Outgoing Authentication Protocol; Editing Ppp Options - ZyXEL Communications Prestige 643 User Manual

FIELD
Session Options:
Edit Filter Sets
PPPoE Idle Timeout (sec)
PPPoE Service Name
Schedule Sets
Once you have completed filling in Menu 11.1 – Remote Node Profile, press [
"Press ENTER to Confirm ..." to save your configuration, or press [

4.1.3 Outgoing Authentication Protocol

Generally speaking, you should employ the strongest authentication protocol possible, for obvious reasons.
However, some vendor's implementation includes specific authentication protocol in the user profile. It
will disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If you encounter the case where the peer disconnects right after a
successful authentication, please make sure that you specify the correct authentication protocol when
connecting to such an implementation.

4.1.4 Editing PPP Options

To edit the remote node PPP options, move the cursor to the Edit PPP Options field in Menu 11.1 –
Remote Node Profile, and press [SPACE BAR] to select Yes. Press [ENTER] to display Menu 11.2, as
shown next.
Remote Node Configuration
DESCRIPTION
Choose Yes and press [
edit the filter sets. See the Remote Node Filter section
for more details.
This value specifies the number of idle seconds that
elapse before the Prestige automatically disconnects
the PPPoE session.
This is valid only when you have chosen PPPoE
encapsulation. If you are using PPPoE encapsulation,
then type the name of your PPPoE service here.
Type in the schedule set number(s), separated by
commas if more than 1 set, according to Menu 26
Schedule Setup. The maximum number of schedule
sets is 4.
ENTER
] to open Menu 11.5 to
ESC
] at any time to cancel.
Prestige 643 ADSL Router
EXAMPLE
No
0
1,3,4,6
ENTER
] at the message
4-5