Table of Contents
Advertisement
The following table describes some of the fields that you may see in third-party TFTP clients.
COMMAND
Host
Type your IP address. 192.168.1.1 is the Prestige default IP address when shipped.
Send/Fetch
Press [Send] to upload the file to the Prestige and [Fetch] to back up the file on your
computer.
Local File
Type the path and firmware file name (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File
The Prestige filename. The firmware filename is ras. The configuration file, is rom-0.
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
10.7.4 Boot Module Commands
When you reboot your Prestige, you will be given a choice to go into debug mode by pressing a key at the
prompt shown in the following screen. In debug mode you have access to a series of boot module
commands, for example ATUR (for uploading firmware) and ATLC (for uploading the configuration file)
already discussed in a previous section.
Bootbase Version: V2.00 | 4/14/2001 13:58:03
RAM: Size = 8192 Kbytes
FLASH: Intel 8M *2
ZyNOS Version: V2.50(BH.0)b5 | 12/12/2001 14:01:55
Press any key to enter debug mode within 3 seconds.
.................................................
Type ATHE to view all available Prestige boot module commands. Some are shown in the next screen.
Most commands aid in advanced troubleshooting and should only be used by qualified engineers.
System Maintenance
Figure 10-19 Option to Enter Debug Mode
Prestige 782R G.SHDSL Router
DESCRIPTION
10-17
Advertisement
Table of Contents
