Advanced Mode: Interfaces; Alarm Inputs - Bosch VCD Series Installation Manual

HD Conference Dome
1.
2.
3.
4.
12.44

Advanced Mode: Interfaces

12.45

Alarm Inputs

Select the type of input for each physical alarm. Select from
either N.O. (Normally Open) or N.C. (Normally Closed) and
provide an optional name for each input.
Bosch Security Systems, Inc.
Click the Enabled check box to activate the alarm.
Choose one of the following alarm inputs:
– Local Input 1: a physical alarm connection.
– Local Input 2: a physical alarm connection.
– IVA/MOTION+: an alarm when IVA or motion detection
is activated.
– Connection: an alarm when an attempt is made to
access the camera's IP address.
Choose one of the following output commands for both
Output 1 and Output 2 settings:
– None: no defined command.
– Aux On: defines a standard or custom keyboard ON
command.
Refer to Section 13 Keyboard Commands by Number,
page 150, for a list of valid commands.
Note: Only commands 1, 8, 18, 20, 43, 60, 80, 86 are
supported. Support for the remaining commands is
scheduled for a future release.
– Aux Off: defines a standard or custom keyboard OFF
command.
Refer to Section 13 Keyboard Commands by Number,
page 150, for a list of valid commands.
Note: Only commands 1, 8, 18, 20, 43, 60, 80, 86 are
supported. Support for the remaining commands is
scheduled for a future release.
– Shot: defines a preset scene from shot 1-64.
Click Set to save and to activate the alarm rules.
Installation Manual
Configuring the HD Conference Dome | en 135
F.01U.265.806 | 1.0 | 2012.03